Technical values
TORQUE SPECIFICATION
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Drive shaft to wheel hub | Step 1 (wheels suspended in the air, press brakes while tightening)/M16 x 72 thread/always use new screws or bolts following removal | Tightening torque | 200 Nm (148 ft. lb.) | ||
| Drive shaft to wheel hub | Step 2 (wheels on the ground)/M16 x 72 thread/always use new screws or bolts following removal | Torque angle | 180° | ||
| Drive shaft to transmission | M10 x 20 thread/always use new screws or bolts following removal | Initial tightening | 30 Nm (22 ft. lb.) | ||
| Drive shaft to transmission | M10 x 20 thread/always use new screws or bolts following removal | Final tightening | +90° |