Preparing Side Section Lower Part For Installation

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Prepare the marked areas for welding and bonding.
   Fig 1: Identifying Side Section Lower Part Marked Areas

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Green	Resistance spot-welding
   Blue	Bonding
   Red	Plug-welding/apply a full weld using inert gas without bonding