Subsequent work

Information 

After installing the sun blind, check that it moves perfectly and smoothly. To do this, move the sun blind drive mechanism forwards and backwards at the motor by hand by actuating it manually using a commercially available hexagon wrench and check that the sun blind fabric folds and moves correctly.

1. Install rear panel. → 60401913 REMOVING AND INSTALLING REAR SLIDING-ROOF PANEL 
2. Install headliner. → 708419 REMOVING AND INSTALLING HEADLINER
3. Carry out standardization if necessary 
4. Switch on ignition.
5. Re-initialise end positions of the sun blind.
   1. 5.1. Press sun blind button forward and keep it pressed.
   2. 5.2. The sun blind closes as far as its limit stop and then opens again.
   3. 5.3. The sun blind button must remain pressed for the entire duration of the standardization run.
   4. 5.4. Release the sun blind when the standardization run is complete.