LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> 60 - Sliding Roof, Tilting Roof >> WM 604019 Removing and installing rear sliding-roof panel >> Installing rear sliding-roof panel

Installing rear sliding-roof panel

Information 

Always use new screws when installing the glass panel.

  1. Installation is performed in reverse order to removal.
  2. Adjust gap dimensions of rear lid → 6X00IN41 GAP DIMENSIONS .
    1. 2.1. When positioning the panel, check that there is an equal gap between the panel and roof aperture. Align the panel in the longitudinal and transverse direction if necessary.
  3. Tighten fastening screw for rear sliding-roof panel to Tightening torque 7 Nm (5 ft lb.)  until secure.
scientia non olet · About LEMON Manuals