Installing motor for glass sliding roof

→ Switch off electric power to drive motor.

→ Make sure it does not switch on again.

→ Check that there is no electric charge.

Information 

Always comply with the regulations for handling ESD-sensitive components!

• Always wear approved work clothes and shoes when carrying out assembly work  .
• Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation  .
• Do not touch electric pins and plug contacts  .

1. Installation is performed in reverse order to removal.
2. Replace and tighten fastening screws for motor for glass sliding roof on glass sliding roof frame. Tightening torque 2 Nm (1.5 ft lb.)