Installing front apron

Installation is performed in reverse order. Pay particular attention to the following: 

1. Tighten fastening screws securing front apron to inner lock carrier to the specified tightening torque. Tightening torque 8 Nm (6 ft lb.) 
2. Tighten fastening screws securing front apron to retaining strip to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.) 
3. Tighten fastening screws securing front apron to outer lock carrier to the specified tightening torque. Tightening torque 8 Nm (6 ft lb.) 
4. Tighten fastening screws securing front apron to lock carrier at the bottom to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.) 
5. Tighten fastening screws securing front apron to lock carrier at the sides to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.) 
6. Tighten fastening screws securing wheel housing liner to lock carrier to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.)