Removing inner door release

Information 

• The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment  .
• The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant  .
• Some steps must be carried out automatically  .
• Some of the repair illustrations show only one side of the vehicle  .

1. Loosen inner door release -1-  at the door lock.
   1. 1.1. Turn bowden cable clip 90° -A-  and remove it from the bracket -B-  .
2. Disengage driver for inner door release.
   1. 2.1. Turn inner door release -A-  until the driver in the mounting is released.
   2. 2.2. Remove driver for inner door release -1-  from the mounting -B-  .