LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> 97 - Cables >> WM 974519 Removing and installing battery-starter wire harness (from external power connection to starter) >> Installing battery-starter wire harness (from external power connection to starter)

Installing battery-starter wire harness (from external power connection to starter)

  1. Installation is performed in reverse order to removal.
  2. Tighten fastening nut securing B+ positive cable to the potential distributor on the longitudinal member. Tightening torque 20 Nm (15 ft. lb.) 
  3. Tighten fastening nut securing ground line to the longitudinal member. Tightening torque 20 Nm (15 ft. lb.) 
  4. Tighten fastening nut securing positive cable at the jump-start point. Tightening torque 7.5 Nm (5.5 ft. lb.) 
  5. Tighten connection terminal securing B+ positive cables to the jump-start point. Tightening torque 20 Nm (15 ft. lb.) 
  6. Tighten fastening nut securing positive cable to B+ positive cable. Tightening torque 7.5 Nm (5.5 ft. lb.) 
scientia non olet · About LEMON Manuals