Installing rear right backrest

Information 

• The illustrations show the other side as an example.
• The removal and installation procedure for this side is practically identical.

1. Guide rear right backrest -1-  into the mount on the body -2-  (- A-  ).
2. Only for vehicles with heated seats:  Connect electric plug connection between the rear seat and backrest.
3. Guide rear right backrest -1-  into the center mount -3-  (- B-  ).
4. Install supporting bow -1-  and secure it Tightening torque 12 Nm (9 ft lb.)  .

   Information 

   Always replace the fastening screws on the seat assembly after customer service and reworking.

   Micro-self-locking or self-tapping screws must not be modified, greased or loosened and then screwed in again.