Installing rear left backrest

→ Always use new fastening screws and nuts following removal.

→ Observe specified tightening torques.

→ Carry out a visual inspection of all re-used parts.

1. Guide rear left backrest -1-  into the mount on the body -2-  (- A-  ).
2. Only for vehicles with heated seats:  Connect electric plug connection between the rear seat and backrest.
3. Guide rear left backrest -1-  into the center mount -3- (- B-)  .
4. Install supporting bow -1-   and secure it Tightening torque 12 Nm (9 ft lb.)  .

   Information 

   Always replace the fastening screws on the seat assembly after customer service and reworking.

   Micro-self-locking or self-tapping screws must not be modified, greased or loosened and then screwed in again.

5. Screw seat-belt buckle for middle seat to the body. Tightening torque 50 Nm (37 ft lb.)