| Required PIWIS Tester software version: |
16.000
(or higher) |
| Type of control unit programming: |
Carry out control unit programming using the 'Campaign' function in the Additional menu
on the PIWIS Tester by entering a programming code. |
| Programming code: |
T3G7M |
| Data record programmed during this campaign: |
0004
When programming is complete, the data record can be read out of the instrument cluster in the → 'Extended identifications'
menu using the PIWIS Tester. |
| Programming sequence: |
Read and follow the information and instructions on the PIWIS Tester
during the guided programming sequence.
Do not interrupt programming
. |
| Procedure in the event of error messages appearing during the programming sequence: |
→ 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "FAULT FINDING"
. |
| Procedure in the event of abnormal termination of control unit programming: |
Repeat control unit programming by entering the programming code again. |