Re-programming instrument cluster

Re-program the instrument cluster using the PIWIS Tester with test software version 16.000 (or higher) installed:

1.1. Carry out general preliminary work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "PRELIMINARY WORK"

1.2. The basic procedure for control unit programming is described in the: → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER .

Specific information on control unit programming during this repair measure:

Required PIWIS Tester software version:	16.000 (or higher)
Type of control unit programming:	Control unit programming is performed using the 'Campaign' function in the Additional menu on the PIWIS Tester by entering a programming code.
Programming code:	C4P5R
Data record programmed during this campaign:	0563 When programming is complete, the data record can be read out of the instrument cluster in the → 'Extended identifications' menu using the PIWIS Tester.
Programming sequence:	Read and follow the information and instructions on the PIWIS Tester during the guided programming sequence. Do not interrupt programming and coding .
Procedure in the event of error messages appearing during the programming sequence:	→ 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "FAULT FINDING" .
Procedure in the event of abnormal termination of control unit programming:	Repeat control unit programming by entering the programming code again.

1.3. Carry out general subsequent work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "SUBSEQUENT WORK"