Re-programming instrument cluster

Before doing any other work, read out the instrument cluster software version using the PIWIS Tester:

1. Highlight the instrument cluster in the 'control unit overview  '.
2. Read off the version shown in the "Software version  " line in the "Extended identifications  " menu:

   If the existing software version is either 0579 or 0585 

   → carry out  the remedial action procedure described below, starting from Step 3  (Reprogramming instrument cluster).

3. Re-program  the instrument cluster  using the PIWIS Tester with test software version 16.000 installed:
   1. 3.1. Carry out general preliminary work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "PRELIMINARY WORK" .
   2. 3.2. The basic procedure for control unit programming is described in: → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER .

      Required PIWIS Tester software version:	16.000  (or higher)
      Type of control unit programming:	Carry out control unit programming using the 'Campaign' function in the Additional menu  on the PIWIS Tester by entering a programming code.
      Programming code:	E9K7S
      Programming sequence:	Read and follow the information and instructions on the PIWIS Tester  during the guided programming sequence. Do not interrupt programming  .
      Software version programmed during this campaign:	1592  When programming is complete, the software version can be read out of the instrument cluster in the → 'Extended identifications'  menu using the PIWIS Tester.
      Procedure in the event of error messages appearing during the programming sequence:	→ 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "FAULT FINDING" .
      Procedure in the event of abnormal termination of control unit programming:	Repeat control unit programming by entering the programming code again.

   3. 3.3. Carry out general subsequent work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "SUBSEQUENT WORK"