LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> 90 - Instruments >> WM 902525 Eliminating symptoms in body interior: Reprogramming instrument cluster (Incomplete display of Chinese characters/SY3715) >> Re-programming instrument cluster

Re-programming instrument cluster

  1. Re-program  the instrument cluster  using the PIWIS Tester with test software version 16.000 (or higher) installed:
  1. 1.1. Carry out general preliminary work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "PRELIMINARY WORK"
  2. 1.2. The basic procedure for control unit programming is described in: → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER .

    Specific information on control unit programming during this repair measure: 

    Required PIWIS Tester software version: 16.000  (or higher)
    Type of control unit programming: Control unit programming is performed using the 'Campaign' function in the Additional menu  on the PIWIS Tester by entering a programming code.
    Programming code: E9K7S 
    Programming sequence: Read and follow the information and instructions on the PIWIS Tester  during the guided programming sequence.
    Do not interrupt programming and coding  .
    Software version programmed during this repair measure: 1592 
    Following control unit programming, the software version can be read out of the instrument cluster control unit in the → 'Extended identifications'  menu using the PIWIS Tester.
    Procedure in the event of error messages appearing during the programming sequence: → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "FAULT FINDING" .
    Procedure in the event of abnormal termination of control unit programming: Repeat control unit programming by entering the programming code again.
  3. 1.3. Carry out general subsequent work for control unit programming as described in → 9X00IN BASIC INSTRUCTIONS AND PROCEDURE FOR CONTROL UNIT PROGRAMMING USING THE PIWIS TESTER - "SUBSEQUENT WORK"
scientia non olet · About LEMON Manuals