Checking adjusting elements

Information 

To restore the original installation position, thereby minimizing the amount of adjustment work required, the following steps must be carried out prior to removal:

• Mark the position of the headlight mounting with respect to fastening screws  .
• Measure and take note of the height of the headlight mounting with respect to the body  .

1. Check adjusting elements.

1. 1.1. Check adjusting elements -1-  for damage and make sure they are seated securely. If an adjusting element -1-  is damaged, it must be replaced. Check that the adjusting elements -1-  are fitted correctly in the body.
2. 1.2. Measure the height -A-  of the adjusting elements -1-  using a calliper gauge and write it down so that you can set the original adjustment height again after the next test step.
3. 1.3. Check that the adjusting rings -2-  are not stiff.
   IMPORTANT: Left thread! It must be possible to turn adjusting ring -2-  without resistance over the entire thread length, otherwise replace adjusting element -1-  .
4. 1.4. Set original height -A-  of the adjusting elements -1-  again.