Removing control unit for ParkAssist
NOTE:
Voltage peaks
- Risk of damage to electrical load or to the control unit
→ Remove the ignition key and switch off load before disconnecting or removing load.
- Switch off ignition and pull remote control out of ignition lock.
- Screw off fastening nuts and remove ParkAssist control unit -1-
.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work .
- Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation .
- Do not touch electric pins and plug contacts .
- Release electric plug connections -2, 3, 4- and disconnect them from the ParkAssist control unit.