Removing Parking Lock Cable
WARNING: This page is about a different variant/trim than selected.
- Disconnect parking lock cable -2-
at the center tunnel.
- 1.1. Undo locking mechanism -1- and unclip the parking lock cable from the support.
- Disconnecting parking lock cable from transmission.
- 2.1. Press off end piece -1- of parking lock cable at parking lock lever using Disassembly Tool Nr. 21 .
- 2.2. Release the parking lock cable from the support -2- and pull it out.
- Remove parking lock cable -1-
.
- 3.1. Disconnect parking lock cable from the body.
- 3.2. Guide parking lock cable through from the engine compartment into the cabin.