LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (9X - Electrical System - General) >> WM 9X00IN Optical WAVEGUIDE - Most Bus (All Models) >> Push-On Connector - Dust Boots >> Dust Boot For Optical Contacts

Dust Boot For Optical Contacts

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

If a LWL is stored, transported, or installed in a vehicle, then the dust boot must only be removed right before the LWL is used in the connector.

When testing the LWL, the dust boot must be put back on.

The dust boots can be removed without the use of a locking mechanism.

Do not touch the exposed contact surfaces while or after removing the dust boot, as otherwise the optical contacts could become damaged or dirty.

scientia non olet · About LEMON Manuals