Setting Parameters
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Parameters must be set after replacing the ParkAssist control unit.
- During parameter setting, it is essential to guarantee the power supply for the Porsche System Tester. A battery charger with a current rating of at least 40 A must be connected to the vehicle battery.
- The Porsche System Tester instructions take precedence and in the event of a discrepancy, these are the instructions that must be followed. Deviations may occur with later software versions.
- The procedure described here has been structured in general terms; different texts or additions may appear in the Porsche System Tester.
- Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on the ignition. Press [>>] to continue.
- Select vehicle type using the cursor keys.
- Using the [→] key, move from the vehicle type to the control units. Perform an automatic control unit search.
- Select "ParkAssist" with the cursor keys and press [>>].
- Select "Parameters" with the cursor keys and press [>>].
- Select "Country version" and press [>>]
- Select "Spare wheel version" and press [>>]
- Tester confirms "Parameter setting was successful".
- Quit the menu.