Removing The Antenna Leads In The Left Rear Spoiler Up To The Connection Point
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Voltage peaks
- Risk of damage to load or to the control unit
→ Remove the ignition key and switch off load before disconnecting or removing load.
- 1 - Auxiliary heater receiver
- 2 - Right antenna amplifier control unit
- 3 - GPS antenna/receiver for the digital radio
- 4 - Left antenna amplifier
- 5 - Telephone antenna
- 6 - Auxiliary heater antenna
- X - Connection point for antenna leads in left rear spoiler
- Insert a plastic wedge between the body and hinge cover on the left and carefully unclip the hinge cover and take out.
- Release the left wiring duct -arrow A- and take off from hinge -arrow B- .
- Release cover -arrows C- , take it off -arrow D- and remove wiring duct from wire harness.
- Loosen the adhesive tape -arrow A- and remove the tie-wrap -1- .
- Release the light brown and curry coloured connector on the right antenna amplifier -arrows B- and pull it off -arrow C- .
- Pull off connector on white connection of right antenna amplifier -arrow D- .
- Unscrew the fastening screw for the ground strap -arrow E- and fastening nut -arrow F- .
- Take off both ground straps and the retaining bracket.
- Remove GPS antenna. → Removing GPs Antenna
- Pull off the antenna for the auxiliary heater from the Velcro strip section and take off.
- Remove left antenna amplifier. → Removing Antenna Amplifier
- Release the fuse for the telephone antenna -arrows A-
and pull off the connector -arrow B-
.
Information
- On vehicles up to model year 2004 the water line for the rear window washer is located in the right antenna lead set.
- On vehicles as of model year 2005 the water line for the rear window washer is located in the left antenna lead set.
- Pull off water line from spray nozzle.
- Remove rubber sleeve from rear spoiler -arrow A- .
- Pull off the wire harness from the Velcro strip sections -arrow B- and remove.
- Unclip the hose for the spray nozzle on the roof frame -arrows A- and disconnect plug connection -arrows B- .
- Remove antenna lines from the two line brackets -arrow C- .
- Pull off the connector for the left rear spoiler wire harness on the left rear roof frame.
- Unscrew fastening nut -1- and remove ground strap together with torsion protection -a- from ground pin.
- Release the support for the left rear spoiler wire harness socket -arrows A- and remove -arrow B- .
- Release the right wire harness socket for the left rear spoiler -arrows A- and press out -arrow B- .
- Release the support for the wire harness socket for the left rear spoiler -arrow C-
, open it up -arrow D-
and take out the lines -arrow E-
.
Information
- The number of antenna connectors can vary, depending on the vehicle equipment.
- Release bracket -arrows A- and remove the plug connections -arrows B- .
- Release the plug connections for the antenna lead -arrow C- and disconnect -arrows D- .
- Unscrew both fastening screws -1- for the receiver for the auxiliary heater.
- Release the antenna connector of the receiver for the auxiliary heater -arrow A- and pull off -arrow B- .
- Release the connector of the receiver for the auxiliary heater -arrow C- and pull off -arrow D- .
- Press out the rubber sleeve in the direction of the left hinge -arrow A- .
- Remove the wire harness on the left hinge to the rear from the rear spoiler and rear roof frame -arrows B- .