Removing Sunroof Panel

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sunroof Panel

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lift sunroof panel.
1. 1.1. Move sunroof panel -1- to the final raised position.
  
  Fig 2: Lifting Sunroof Panel
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide sun blind backwards.
Unclip bellows.
1. 3.1. Unclip bellows -2- at the top and bottom in the front area towards the centre of the vehicle.
  
  Fig 3: Sliding Sun Blind Backwards
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unhook bellows.
1. 4.1. Unhook bellows -2- at the top in the rear area backwards out of the retaining pivot -4- .
  
  Fig 4: Locating Retaining Pivot
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 4.2. Push bellows -2- at the bottom forwards in the rear area.
3. 4.3. Remove bellows -2- .
  
  Fig 5: Pushing Bellows
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 6: Removing Bellows
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screws.
1. 5.1. Unscrew fastening screws -3- on cover for sliding roof -1- .
  
  Fig 7: Sliding Roof
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove sunroof panel.

Fig 8: Removing Sunroof Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.