Function Test Following Assembly Work
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- A malfunction occurs only after the vehicle is locked for the first time. In other words: if a door handle was fitted incorrectly, the affected door can be opened and closed without difficulty until the vehicle is locked for the first time. After that, the door cannot be opened from inside or outside. Given this, it is important to perform a function test before the door is closed.
- Do not close vehicle door after installing door handle.
- With the door open, use a screwdriver to engage the bolt in the door lock fully in the second notch.
- Lock vehicle with the remote control.
- Unlock vehicle with the remote control.
- Press door handle on open door.
Information
- If the bolt in the door lock does not open, press the door button in the driver's door to make sure that the individual door opening function is deactivated. If the door lock still does not open, the door lock was assembled incorrectly.