Pre-Treating Adhesive Flanges On Vehicle Body
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The table below shows how to use cleaners, primers and activators when preparing the adhesive surface.
| Preparing the window flange for installation | ||
| Old flange (old paint job) | New flange (new paint job) | |
| Cut back adhesive bead | Cleaner | |
| Clean flange surface | ||
| Activator | Primer | |
| Activate adhesive bead (only necessary after idle periods > 24 h) |
Prime flange surface | |
| Apply adhesive | ||
| Install glass | ||