Removing Key Bit

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Release the key of the remote control and carefully jam a crosshead screwdriver -A- between remote control and key so that the key does not engage in its end position.

Fig 1: Removing Roll Pin
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Place a tool, e.g. a 10-mm open-ended/ring wrench -B- , between the key bit and the working surface.
Drive out the roll pin -C- - spring steel (max. diameter 1.5 mm) - with a tool such as a mandrel.
Fully pull out the roll pin with a pair of pliers.

Fig 2: Pulling Out Roll Pin With Pliers
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull out key bit -arrow- from the remote control.

Fig 3: Pulling Out Key Bit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.