Processing Body Acoustic Foam 2K-AFS VARIO: Processing

Information 

Always observe the relevant work safety regulations when working with the foam filler.

→ Ventilate the work area well.

→ Never ingest or inhale.

→ Read specific information on the Hazard Sheet.

→ Wear personal protective gear.

Information 

The work area must be free of dust and grease.

Remove loose parts.

Do not wet the area beforehand.

Observe temperature limits: 

• Can and ambient temperature: 10-35°C 
• Optimal temperature: 18-23°C 

Information 

Apply sparingly since the volume of the foam filler will expand by approx. 50-100 % in open areas and by approx. 100-200 % in cavities. Approx. 0.25 litres of foam volume is produced per second of foam time (free-foaming). The foam filler is silver-grey. Remove fresh foam residues immediately with PU cleaner. Hardened foam residues can only be removed mechanically afterwards. Always remove foam from the can following activation.

• Activation process: 
• 1. Break open the seal on the activation lid.
• 2. Use a piece of wire to pull the activation lid out as far as it will go (approx. 11 cm up to the notch).
• 3. Break off the wire at the required rupture point (notch) over the valve.
• 4. Screw plastic adapter into the valve.
• 5. Shake can vigorously up and down (approx. 20 times).
• 6. Release foam downwards out of the can with the valve.
• Subsequent work: 

  The hardened foam filler can be processed further by sanding, cutting or sawing. It can be painted or varnished immediately.