Installing Centre Cover

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installation Position Of Centre Cover

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position centre cover -2- on the body -arrows A- , guide it in at the front under the wheel housing liner -3- and slide it forward -arrow B- .

Fig 2: Installing Centre Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws -1- . → Tightening torque: 2 Nm (1.5 ftlb.)
Slide cover -1- into the centre cover -2- (-arrow A- ) and clip it in by pushing it upwards -arrow B- .

Fig 3: Installing Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position rear lifting platform holder -2- on the body -arrow- and secure with the fastening screw -1- . → Tightening torque: 9 Nm (6.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb. )

Fig 4: Installing Rear Lifting Platform Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.