Removing Relay Carrier In Plenum Chamber E-Box

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Relay Carrier, Plenum Panel E-Box

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Undo fastening screws -1- -arrows- and remove lid.

Fig 2: Removing Lid
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip harness -arrow- .

Fig 3: Unclipping Harness
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect plugs -arrows A- and remove both wire harnesses from bracket -arrows B- .

Fig 4: Disconnecting Plugs And Removing Wire Harnesses From Bracket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Lift relay carrier out and upwards -arrows- .

Fig 5: Pulling Relay Carrier Up And Out
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screws -arrows 2- .

Fig 6: Unscrewing Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release both relay carriers -arrows A- and pull them up and out -arrows B- .

Fig 7: Releasing Both Relay Carriers And Pull Them Up And Out
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release the fuse carrier -arrows C- and pull it up and out -arrow D- .
Release sockets -arrows A- and press downwards and out -arrow B- .

Fig 8: Releasing Sockets And Press Downwards And Out
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove top half of casing.
Place harnesses to the side, pull bottom half of casing upwards out of bracket and remove.