Removing Wiring Harness For Additional Heating

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Wiring Harness For Additional Heating

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Release connector -Arrow A- and pull off -Arrow B- .

Fig 2: Pulling Off Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release connector -Arrow A- and pull off -Arrow B- .

Fig 3: Pulling Off Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release inner connector -1- -Arrow A- and pull it off -Arrow B- .

Fig 4: Pulling Off Inner And Outer Connectors
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release outer connector -2- -Arrows C- and pull off -Arrow D- .
Pull off line together with water pipe clip -Arrow- .

Fig 5: Pulling Off Line From Water Pipe
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Mark the exact installation position of the line in the clips with adhesive strips -A- .

Fig 6: Marking Installation Position Of Line
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Open the clips -Arrows B- and remove the line -Arrow C- .
Unscrew clips -Arrows- and remove from threaded bolt.

Fig 7: Removing Clips
Courtesy of PORSCHE CARS NORTH AMERICA, INC.