Removing Front Wire Harness

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Wire Harness Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unclip plug connections on the front apron at the right.
1. 1.1. Unclip plug connections -1 and 2- on the front apron -arrows A- .
2. 1.2. Unclip front wire harness -4- at the line bracket -3- (-arrow B- ).
  
  Fig 2: Unclipping Plug Connections On Front Apron
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release connector -1- (-arrow A- ) and pull it off the fog light -2- at the left and right -arrow B- .

Fig 3: Pulling Connector Off Fog Light
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Take front wire harness -1- out of the air grille holders at the left and right -arrows- .

Fig 4: Removing Front Wire Harness From Air Grille
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip front wire harness -1- from the radiator grille holders -arrows- .

Fig 5: Unclipping Wire Harness
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull off connector on sensor for ParkAssist.
1. 5.1. Release clips -arrows A- and remove sensor for ParkAssist -1- (-arrow B- ).
2. 5.2. Release connector -2- (-arrow C- ) and pull it off sensor for ParkAssist -1- (-arrow D- ).
  
  Fig 6: Pulling Off Connector On Sensor For Parkassist
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove front wire harness.