Installing Main Wiring Harness - Dashboard Area

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Press wire harness with wiring duct into pedal block -Arrow A- until locking tabs -B- are felt to engage.

Fig 1: Pressing Wire Harness With Wiring Duct Into Pedal Block
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Apply a suitable rubber lubricant (tyre mounting paste) to rim of centre rubber sleeve -A- and press in rubber sleeve until it is felt to engage in the firewall. -Arrow B- .

Fig 2: Pressing Rubber Sleeve
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Apply a suitable rubber lubricant (tyre mounting paste) to rim of left rubber sleeve -C- and press in rubber sleeve until it is felt to engage in the firewall -Arrow D- .
Fasten line to the clip with a new tie-wrap -A- .

Fig 3: Fastening Line To Clip Using Tie-Wrap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Apply a suitable rubber lubricant (tyre mounting paste) to rim of right rubber sleeve -B- and press in rubber sleeve until it is felt to engage in the firewall -Arrow C- .