Installing Rear Brake Calliper

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Replace screws and lock nuts.
Never use an impact bolter to loosen and tighten the brake calliper on the wheel carrier.
Pay attention to tightening torques → WM 4200TW Tightening torques for rear axle .

The brake calliper is installed in reverse order.

Fit the brake calliper.
Fit the brake line and cable holder.
Clip in connector for wear indicator.
Position disc brake pads by operating the brake several times.