Installing Hydraulic Pump
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Only use Pentosin CHF 202 to fill the hydraulic system.
- Pay attention to the hydraulic fluid level.
- Replace sealing rings.
- Use correct tightening torques → WM 4300TW TIGHTENING TORQUES
- Use correct tightening torques. → Tightening Torques
- Fit the hydraulic pump.
- Fit pulley on the hydraulic pump and screw in the screws.
- Fit drive belt in correct position and tension → Checking drive belt .
- Tighten the pulley on the hydraulic pump.
- Fit the hydraulic lines and make sure the hydraulic lines are routed correctly.