Installing Hydraulic Pump (Cayenne V6)
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Only use Pentosin CHF 202 to fill the hydraulic system.
- Pay attention to the hydraulic fluid level.
- Replace sealing rings.
- Use correct tightening torques → WM 4300TW TIGHTENING TORQUES
- Use correct tightening torques → Tightening Torques
- Fit the hydraulic pump. → Tightening torque: 23 Nm (17 ft lbs.)
- Fit pulley on the hydraulic pump and screw in the screws.
- Fit drive belt in correct position and tension Checking drive belt .
- Tighten the pulley on hydraulic pump. → Tightening torque: 23 Nm (17 ft lbs.)
- Fit both hydraulic lines. → Tightening torque: 30 Nm (22 ft lbs.)+/-3 Nm (+/-2.0 ft lbs.) → Tightening torque: 10 Nm (7.5 ft lbs.) Remove hose clamp 3094.