LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (24 - Fuel System - Electronic Ignition) >> WM 244019 Removing And Installing High-Pressure Fuel Injector (DFI) >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit high-pressure distribution pipes (fuel rails). → Installing Fuel Distribution Pipe (Fuel Rail) 
  2. Connect cable plugs for injectors.
  3. Fit intake-air distributor (intake module). → Installing Intake-Air Distributor 
  4. Connect the battery.
  5. Perform a test drive. Make sure the high-pressure pipes and threaded joints are sealed properly (visual inspection with engine running).
  6. Read out engine control unit fault memory after completing the work and print log. Compare with the previous log.
scientia non olet · About LEMON Manuals