Assembling Rear Lid

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Assembling Of Rear Lid

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing lateral adjusting buffer
1. 1.1. Screw in blind rivet nuts for the lateral adjusting buffer -6- on the rivet gun, insert on the rear lid and rivet using hand-held blind rivet nut device NR.125.
2. 1.2. Place lateral adjusting buffer -3- on the rear lid and screw in fastening screws -1, 2- -Arrows C- .
  
  Fig 2: Installing Fastening Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Installing blind rivet nuts for the number plate holder.
1. 2.1. Screw in blind rivet nuts for the number plate holder -7- on the rivet gun, insert on the rear lid -Arrows D- and rivet using hand-held blind rivet nut device NR.125.
  
  Fig 3: Installing Blind Rivet Nuts For Number Plate Holder
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Installing blind rivet nuts for the trim strip holder and the rear window buffer
1. 3.1. Screw in blind rivet nuts for trim strip holder -8- and rear window buffer -9- on the rivet gun, insert on the rear lid and rivet using hand-held blind rivet nut device NR.125.
  
  Fig 4: Installing Blind Rivet Nuts For Trim Strip Holder And Rear Window Buffer
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Installing buffer for rear window
1. 4.1. Screw in buffer for rear window -4, 5- -arrows E- and tighten to the specified tightening torque → Tightening torque: 1.0 ft lbs..
  
  Fig 5: Installing Buffer For Rear Window Of Screw
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Installing mounting points for the side trim.
1. 5.1. Insert plastic clips -10- from the outside -Arrows H- for the mounting points of the side trim.
  
  Fig 6: Installing Mounting Points For Side Trim
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.