Installing Front Wheel Housing Liner

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Installing front wheel housing liner

Fig 1: Identifying Installation Position Of Front Wheel Housing Liner

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Install wheel housing liner.
1. 1.1. Fit wheel housing liner -1- in -direction of arrow- and align it.
2. 1.2. Check wheel housing liner -1- close to the side direction indicator and along the wheel arch to make sure that it is seated correctly.
3. 1.3. Tighten fastening screws -2- and fastening nuts -3- . → Tightening torque: 1.5 Nm (1.0 ft lbs.)+/-0.5 Nm (+/- 0.5 ft lbs.) → Tightening torque: 1.5 Nm (1.0 ft lbs.)+/-0.5 Nm (+/-0.5 ft lbs.).
  
  Fig 2: Installing Front Wheel Housing Liner
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure servo valve line at the left wheel housing liner.
1. 2.1. Route servo valve wire harness and push it onto the left wheel housing liner using the retaining clips -arrows- .
  
  Fig 3: Securing Servo Valve Line At Left Wheel Housing Liner
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.