Installing Auxiliary High Beam Halogen Bulb

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Incorrect handling of bulbs

Risk of damage to bulbs and the bulb housing

→ Switch off ignition and remove ignition key.

→ Switch off the relevant loads when changing bulbs.

→ Only use bulbs listed in the bulb table.

→ Only install clean bulbs that are free of grease.

→ Always use a cloth or soft paper when working with bulbs.

→ Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.

→ In certain states, it is compulsory to carry spare light bulbs.

Information

Observe instructions in → Bulb Table

Insert auxiliary high beam bulb -1- into the bulb holder for the auxiliary high beam headlight -2- (-Arrow- ).

Fig 1: Installing Auxiliary High Beam Headlight Bulb
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert bulb holder for auxiliary high beam headlight -1- into the main headlight -Arrow A- and turn it clockwise -arrow B- .

Fig 2: Installing Bulb Holder For Auxiliary High Beam Headlight
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit cover.
1. 3.1. Insert cap -1- down into the guides on the main headlight and swivel it up -Arrows A- .
2. 3.2. Press cap -1- onto the main headlight until the two clips engage securely -Arrows B- .
  
  Fig 3: Fitting Cover
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.