Tools And Materials
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
From model year 2008 onwards, new hydraulic bearings with a larger diameter were introduced in parallel for the bearing -A- . The supplement set T10230/14-16 must be used for these bearings.
The procedure for pressing the bearings in and out is the same for both bearings.
Lower trailing arm with rubber-metal bearings A, B, C.
Tool set T10230 .
| Item | Designation | Source | Explanation | |
|---|---|---|---|---|
| -A- | Tubular piston cylinder VAS 6178 | The tubular piston cylinder is used with the pneumatic hydraulic pump VAS 6179. | ||
| Tool set T10230 | Assembly fixture T10230 | Tool set for pressing hydraulic bearings/rubber-metal bearings in and out, comprising No. 1-15. | ||
| -1- | Threaded rod - assembly fixture T10230 | Used in the tubular piston cylinder VAS 6178 -A- . | ||
| -2- | Nut with collar - assembly fixture T10230 | Screwed onto the threaded rod -1- . | ||
| -4- | Pressure piece 40 - assembly fixture T10230 | For pressing out the bearing -C- . | ||
| -5- | Pipe 56 - assembly fixture T10230 | For pressing out the bearing -B, C- . | ||
| -7- | Adjusting washer - assembly fixture T10230 | Screwed into the tubular piston cylinder vas 6178 -A- with two countersunk screws. For pressing out bearings -A, B, C- . For pressing in bearing -C- . | ||
| -8- | Support - assembly fixture T10230 | For pressing in bearing -C- . | ||
| -9- | Pipe 72 - assembly fixture T10230 | For pressing out the bearing -A- . | ||
| -10- | Pressure piece 60 - assembly fixture T10230 | For pressing in bearing -B- . | ||
| -11- | Support - assembly fixture T10230 | For pressing in bearing -A- . | ||
| -12- | Ring - assembly fixture T10230 | Screwed into the tubular piston cylinder VAS 6178 -A- with two countersunk screws. For pressing in bearings -A, B- . | ||
| -13- | Pressure piece 45 - assembly fixture T10230 | For pressing out the bearing -B- . | ||
| -T10205/13- | Pressure head attachments T10205 | Pressure head from assembly fixture T10205 (!); screwed into the tubular piston cylinder VAS 6178 -A- . | ||
| -14- | Washer - assembly fixture T10230 | Placed on the threaded rod -1- . | ||
| -15- | Nut - assembly fixture T10230 | Commercially available M14 nut. Screwed onto the threaded rod -1- . | ||
| T10230/14-16 | Supplement set for T10230 | For pressing out and in bearing -A- with larger diameter. | ||