Tools And Materials: Tools

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Tool overview for chassis sub-frame bearings assembly fixture T10301

Fig 1: Overview Of Chassis Sub-Frame Bearings Tool

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

-A- Hydraulic cylinder VAS 6178 (The hydraulic cylinder is used together with the foot pump VAS 6179 and the pressure gauge with connecting cable VAS 6179/1 -B- .)
-1- - Threaded rod (Inserted into the tubular piston cylinder -A- .)
-2- - Threaded nut (Screwed onto the threaded rod -1- .)
-3- - Pipe (For pressing out the chassis sub-frame bearings.)
-4- - Ring (For pressing out the chassis sub-frame bearings.)
-5- - Press-out plate (For pressing out the chassis sub-frame bearings.)
. -6- - Pressure piece (For pressing in the chassis sub-frame bearings.)
-7- - Press-in plate (For pressing in the chassis sub-frame bearings.)
-8- - Ring (For pressing out the chassis sub-frame bearings.)
-9- - Spacer sleeve (For pressing out the chassis sub-frame bearings together with pipe -3- .)
-10- - Pressure piece (For pressing in the chassis sub-frame bearings.)
-11- - Spacer sleeve (For pressing in the chassis sub-frame bearings.)

Porsche supplement set T10301/20

-2- - Threaded nut (Screwed onto the threaded rod -1- .)
-12- - Press-out ring (For pressing out the chassis sub-frame bearings.)
-13- - Pressure piece (For pressing in the chassis sub-frame bearings.)
-14- - Bush (For pressing out the chassis sub-frame bearings.)

Fig 2: Identifying Porsche Supplement Set (T10301/20)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Counter support, 0 - 40 mm Nr.106

Internal puller Nr.108

Separating device, 12 - 115 mm ø Nr.111