Replacing Servo Motor On Transfer Gear
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- If a new servo motor is to be installed, it will be supplied in Low Range setting, off-road driving programme.
- If a new servo motor is installed, the transfer gear control unit must be replaced. → 391319 REMOVING AND INSTALLING TRANSFER GEAR CONTROL UNIT
- Install a new servo motor on the transfer gear. → 397819 REMOVING AND INSTALLING SERVO MOTOR ON TRANSFER GEAR
- Install a new transfer gear control unit. → 391319 REMOVING AND INSTALLING TRANSFER GEAR CONTROL UNIT