LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (19 - Engine - Cooling) >> WM 195019 Removing And Installing Coolant Pump On DFI Engines (Except Cayenne Diesel, Cayenne S TRANSSYBERIA Tip, Cayenne TRANSSYBERIA Man, Cayenne GTS Tip "PORSCHE Design Edition 3") >> Removing Coolant Pump

Removing Coolant Pump

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen drive belt around the water pump. For details, see → Removing and installing drive belt
  2. If the pulley has to be removed in order to replace the water pump, counter the pulley using a commercially available mandrel or screwdriver and then loosen the screws on the pulley.
  3. Turn the drive wheel for the coolant pump in such a way that the fastening screws can be reached through the holes in the pulley -arrows-  .
    Fig 1: Locating Coolant Pump Fastening Screws
    G09409707Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Pull coolant pump out of the crankcase.
    Fig 2: Identifying Coolant Pump
    G09409708Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals