Initialising Final Deactivation
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- After the motor is replaced, the limit stops must be re-initialised.
- If the limit stops are not initialised, the two LEDs on the switch flash at the same time.
- Once initialisation is completed successfully, the upper LED lights up in the retracted state, while the lower LED is continuously lit in the extended state.
- Extend the trailer hitch until the limit stop is reached and the motor switches off automatically. Keep the switch pressed when doing this.
- Retract the trailer hitch until the limit stop is reached and the motor switches off automatically. Keep the switch pressed when doing this.