Installing Side-Section Trim

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position Of Side-Section Trim

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position Side-Section Trim -2- On The Side Member -Arrow- And Secure With The Fastening Screws -1- .

Fig 2: Installing Side-Section Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Lift Off Rear Wheel Housing Liner -1- In The Lower Area -Arrow A- And Tighten The Fastening Screws -2- (-Arrow B- ). → Tightening Torque: 2.5 Nm (2.0 Ftlb.)+/-0.5 Nm (+/-0.5 Ftlb.)

Fig 3: Tightening Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw In Fastening Screws -1- On Rear Wheel Housing Liner -2- In The Lower Area -Arrow- . → Tightening Torque: 2.5 Nm (2.0 Ftlb.)+/-0.5 Nm (+/-0.5 Ftlb.)

Fig 4: Fastening Rear Wheel Housing Liner
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position Cover -1- On The Side-Section Trim -2- And Press It In -Arrow- .

Fig 5: Positioning Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.