Removing Moulding For Wing

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

The moulding is destroyed during removal.

Heat up moulding with a hot-air gun to approx. 60°C.
Open door.
Using an assembly wedge, traverse between moulding and cover and lift off the moulding.

Fig 1: Removing Moulding For Wing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove moulding completely, reheating if necessary.
Close the door.
To protect from damage, mask painted surfaces along the top and bottom edges.
Warm up adhesive tape residue off the cover and scrape off with an assembly wedge.