Removing Lid Hinge Trim
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Remove hinge cover.
- 1.1. Insert a plastic wedge between the body and hinge cover -1- .
- 1.2. Carefully unclip and remove the hinge cover -1- .
- Remove outer hinge cover.
- 2.1. Undo fastening screws -3- .
- 2.2. Remove outer hinge cover -2- -(Arrow B)- .
- Remove inner hinge cover.
- 3.1. Unclip inner hinge cover -4- -Arrows C- .
- 3.2. Swivel out inner hinge cover -4- -Arrow D- and remove it.
- Remove wiring duct on lid hinge.
- 4.1. Remove wiring duct -5- from lid hinge -Arrow E- .
- 4.2. Open wiring duct -5- -(Arrows F)- and remove the cover -6- -(Arrow G)- .
- 4.3. Remove wiring duct -6- from wire harness -(Arrow H)- .
- Remove wiring duct on rear window hinge.
- 5.1. Release wiring duct -7- -(Arrow I)- and remove it from rear window hinge -(Arrow K)- .
- 5.2. Release cover -8- -(Arrows L)- and remove it -(Arrow M)- .
- 5.3. Remove wiring duct -7- from wire harness -(Arrow N)- .