Removing Sliding/Tilting Roof Trim

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sliding/Tilting Roof Trim (1 Of 2)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fig 2: Identifying Sliding/Tilting Roof Trim (2 Of 2)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Remove sliding roof cover. → Removing Sliding/Tilting Roof Trim
Close sliding/tilting roof trim.
Unscrew fastening screw -2- on both sides at the guide elements -3- .

Fig 3: Unscrewing Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Lift guide elements -3- -Arrow A- and push all the way to the front over the sliding/tilting roof trim -1- -Arrow B- . Simultaneously push the sliding/tilting roof trim -1- to the rear -Arrow C- .

Fig 4: Lifting Guide Elements
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fig 5: Locating Sliding/Tilting Roof Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Lift the sliding/tilting roof trim -1- -Arrow D- and remove over the guide elements -3- -Arrow E- .

Fig 6: Lifting Sliding/Tilting Roof Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.