Removing Trim Under The Dashboard On The Driver's Side
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Remove dashboard moulding on driver's side. → Removing Trim Strips For Dashboard On The Driver's Side
- Remove cover under dashboard on driver's side. → Removing Cover Under Dashboard
- Remove ignition key.
- Remove fuse box cover.
- 4.1. Unclip fuse box cover -1- using a plastic wedge on the retaining clips -2- and swivel it outwards -arrow A- .
- 4.2. Remove the fuse box cover -1- to the rear -arrow B- .
- Remove trim panel under dashboard on the driver's side.
- 5.1. Unscrew the fastening screws -3-
and swivel the trim panel under the dashboard on the driver's side -4-
downwards -arrow C-
. Pull out the trim panel under the dashboard on the driver's side -4-
over the guide -5-
(-arrow D-
).
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 5.1. Unscrew the fastening screws -3-
and swivel the trim panel under the dashboard on the driver's side -4-
downwards -arrow C-
. Pull out the trim panel under the dashboard on the driver's side -4-
over the guide -5-
(-arrow D-
).
- Disconnect the plug connections.
- 6.1. Release -6 and 7- and pull off -arrows E- plug.
- Unclip the bowden cable for the parking brake release.
- 7.1. Using a screwdriver, carefully unclip the sleeve -8- and ball joint -9- of the Bowden cable upwards out of the release lever -10- (-arrow- ).
- Take off the trim panel under the dashboard on the driver's side.
- 8.1. Pull the trim panel under the dashboard on the driver's side -4- out of the guides -11- (-arrow F- ) and take it out towards the rear.