Removing Engine Guard

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Remove front cover at the front apron.
1. 1.1. Remove eight screws. -arrows-
  
  Fig 1: Locating Cover Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 1.2. Remove cover from front apron.
  
  Fig 2: Removing Cover
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove front engine guard. To do this, undo nine screws. -1, 2 and 3-

Fig 3: Locating Engine Guard
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove rear engine guard. To do this, remove two screws on the transverse strut -2- . Take the component out of the clamps on the transmission cross member.

Fig 4: Locating Rear Engine Guard
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove transverse strut if necessary. Undo two nuts. Undo middle screw.

Fig 5: Locating Transverse Strut
Courtesy of PORSCHE CARS NORTH AMERICA, INC.