Balancing/Optimising Wheels: General
Excessive rough running of the wheels, caused by wheel imbalance, flat spots and securing the wheel on the vehicle, causes vibrations and shaking in the steering wheel. This is turn leads to increased wear of various parts of the chassis.
Even if wheels are correctly balanced, rolling and steering imbalance can still occur, for example in the case of
- excessive geometric errors (radial and lateral runout),
- radial force variations (softer and more rigid areas in the Tire).
Information
- Achieving a good result requires utmost care, observance of the instructions and procedure, and attempting to eliminate even the very last gram of imbalance.
Recommendations/requirements
Wheel suspension elements must be in good technical order.
The wheels must be clean with no foreign objects in the Tire.
Use a Tire measuring gauge, e.g. measuring gauge Nr.136 to check radial and lateral runout values on wheels without flat spots. Values of less than 1 mm are desirable - around 0.5 mm would be better.
To limit the number of radial runout errors and to optimise smoothness of rolling, it is a good idea - and even necessary in individual cases - to match the Tire (i.e. to fit it in a favourable position with respect to the wheel). Follow tips and fitting instructions as well as information on Tire mounting paste for tires.
If the disc wheels (wheels without tires) are perfect but the complete wheels have large axial and radial runout values (due to ply breakage or other damage), it may be necessary to replace the Tire.
Model year Balance used wheels only after they have been warmed up by driving, otherwise flat spots will simulate imbalance. Never perform matching in the case of flat spots. In the event of flat spots, wheels must be warmed up by driving 25 - 30 km on a motorway. Lift up the vehicle immediately on return. This prevents new flat spots from forming.
Correct Tire pressure is an important prerequisite.
Place the balancing weights at the prescribed position.