Attaching The Balance Stick-On Weights
WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Remove the protective film just before sticking on the weight, as prolonged exposure to the air will reduce the bonding strength.
- Pay attention to cleanliness.
- Determine exact position of the balancing weights (if necessary, temporarily stick on the balancing weights with a strip of adhesive tape until the correct position is determined).
- Prepare bonding surface on the rim. The bonding surface must be perfectly clean and free of grease.
- Remove protective paper from the bonding surface of the weight and press the weight firmly into place.
- The balance stick-on weight must be in uniform contact over the entire surface.
- Check the balancing weight is seated firmly. A weight freshly affixed weight must not detach itself from the rim under application of a shear load at right angles to its longitudinal axis.